Clear Coat sand through
- This topic has 5 replies, 4 voices, and was last updated 12 years, 6 months ago by .
- Posts
New paint job and had a bad run in the clear..Did the ultimate sin and sanded through to the paint. What is the proper way of repairing this? Still have good base underneath, can I spray this area again and reclear the pannel?
Are you using waterborn or solvent???
solvent
I’d (block) sand it down, prime, block and paint if you want to eliminate the possibility of seeing it again after you respray. :chair
Yep, as Jimmo said, that is the safest bet. Priming will also eliminate the chance of any wrinkling/issues re-baseing over your fresh paint.
another reason water is better than solvent…. if it were water you could just blow more base over it… just sayin 😛
- You must be logged in to reply to this topic.