Frame pulling

Back to: Introductions3 Replies

Home / Forums / Main Forum / Introductions / Frame pulling

  • Author
    Posts
  • Dan
    August 10, 2015 at 2:39 am #48931

    Hey guys I’m a painter by trade who has been getting into a lot more bodywork in the past year or two…. What I’m really looking to learn about is frame pulling . I know a little bit but not much and have never apprenticed under a bodyman . I looked online but couldn’t find too much regarding the basics and fundamentals of straightening frame using a drive on or wedge clamp set up … I have frame machines that I would like to start attempting to to frame work on . Any website links or info would be appreciated !

    Scott
    August 10, 2015 at 3:03 am #48934

    Have you signed up with I-CAR? They have some of the best info/ education in the business IMO.

    Dan
    August 10, 2015 at 3:54 am #48935

    I have not been to any icR courses in 5+ years, I would like to get more points though , I will have the opportunity to take more through my employer in 2016

    Dan
    August 16, 2015 at 11:11 pm #48949

    No lazers would be measuring with trams, and no full frame just unibody

  • Author
    Posts
  • You must be logged in to reply to this topic.