mark

Forum Replies Created

Viewing 15 posts - 61 through 75 (of 139 total)
  • Author
    Posts
  • January 27, 2011 at 4:32 pm #27704

    Hey jimmo. I remember many years ago i learned to sharpen a dril bit at a trade school and i also believe it was 15-20 degree’s. do like the other techs do jimmo, just go on the snap on truck and buy drill bits:rofl

    January 26, 2011 at 6:42 am #27628

    ben i have the ball bearing sliders.

    January 26, 2011 at 4:20 am #27621

    ben i looked at the instruction book and it shows a slot were you suppose put a screwdriver thru.

    January 26, 2011 at 3:43 am #27619

    Theres a slot and in the slot like part of the rail that sticks up alittle.

    January 20, 2011 at 5:50 am #27461

    hey ben you do nice work :cheers

    January 13, 2011 at 5:23 am #27100

    I was thinking that a D.A. would catch all the rust and get it down to the bare metal.

    January 10, 2011 at 3:56 pm #26999

    welcome Leo :welc

    January 10, 2011 at 9:34 am #26984

    great job :pcorn:

    January 8, 2011 at 5:30 pm #26924

    don you do really nice work :clappy :pcorn:

    January 8, 2011 at 6:36 am #26920

    You do nice work bondo and a busy shop is always good:pcorn:

    January 4, 2011 at 4:54 pm #26818

    it sounds like a great plan but alot of work and i have to agree on skippin the skim:pcorn:

    January 2, 2011 at 5:12 am #26730

    really nice pictures nexon you do really nice work:cheers

    December 31, 2010 at 1:44 pm #26666

    Hey bondo just wanna wish you and yours a wonderful new years.:cheers :cheers :cheers

    December 30, 2010 at 4:43 pm #26601

    If you wanna get panels really straight then you have to guide coat between stage of block sanding. The guide coat will show your highs and lows. All the panels should be block by hand.

    December 25, 2010 at 5:53 pm #26451

    :welc

Viewing 15 posts - 61 through 75 (of 139 total)