Darren

Forum Replies Created

  • Author
    Posts
  • March 4, 2010 at 9:57 pm #19883

    Looking good so far. You’re not worried about adhesion issues with the resin and plastic? Are you going to put some fiberglass mat on top of the fleece? All those little holes look like a nightmare to plastic weld, so the fleece and resin were probably the best route.

    January 19, 2010 at 10:35 am #18779

    I got sick of my flat paint real quick. However from my experience, Hot Rod Flatz didn’t pick up too much dirt, I have maybe two specks on the entire car, and the car was sprayed in a garage with only a swept floor.

    January 15, 2010 at 1:55 am #18642

    If I do skip the sealer, should I sand over the 400 grit areas with 800 since the brown is a fine metallic?

    January 14, 2010 at 10:31 pm #18637

    That’s what I was thinking also, just wanted another opinion. Thank you!

    I’ll order a gallon of SPI black sealer tonight.