Joe t

Forum Replies Created

  • Author
    Posts
  • Joe t
    September 24, 2012 at 6:43 pm #38366

    Thanks a ton man, I was hooked on the quick release thing lol and when I tried to take it off without going through that whole it kept slipping off. So what is the actual use of that hole I always thought it might be for the hose to use as a watersander but wasn’t sure. As old as these sanders are you would figure the internet would be littered with breakdowns and rebuilds on them.

    Joe t
    September 23, 2012 at 4:02 am #38354

    also this is an older one and possibly doesn’t have the pressure lock system?

    Joe t
    September 23, 2012 at 3:45 am #38353

    how long have you had it?

    Joe t
    September 22, 2012 at 6:51 am #38349

    http://www.youtube.com/watch?v=UqLPdVL8Vao here is a little video on them.

    I have a 4500 and am thinking about getting the 600 because I found one for 110 new

    Joe t
    March 23, 2012 at 7:12 am #36468

    bad indeed lol

    Joe t
    March 11, 2012 at 11:16 am #36275

    Gotcha, I’m kinda new to the game only worked at a small shop so not in with all the lingo. lol But yeah I was looking at some but they was starting at 1200 and I got my stud welder for 250. I’m just tryin to get started right now, hopefully I can grab one later if depending on how everything goes.

    Joe t
    March 10, 2012 at 10:24 am #36250

    Also I have the 1.2 cap/needle.

    Joe t
    March 10, 2012 at 10:22 am #36249

    Good, I hope I picked a gun that will suit me well. It was a toss up for me rather to get the HVLP or the Rp version of the 4000.

    Since this is going to be my all around gun for a little while, at least turn some profit to pay for my investments so far.

    I will be using for everything but primer.

    Do you have any issues with metallic/pearls water or solvents?

    Joe t
    March 10, 2012 at 10:18 am #36248

    A Maxi?

    I thought there was alot of sata users here, but my other thread regarding metallic/pearls with 4000 rp hasn’t got many hits.

    Joe t
    March 10, 2012 at 4:26 am #36240

    That’s for all the replies.

    Sucks that the snap on I’ve drops pins but I guess it is something I must deal with now since that is the one I got.
    Ended up getting it got 250 I don’t even think out has been used, didn’t come with the clamp but I think that it was a option from the dealer.

    And this panel beater you speak of sounds expensive. Lol

    Any of you guys have a sata 4000 rp?

    Joe t
    March 9, 2012 at 4:50 pm #36229

    Thanks, been looking for a good auto refinishing forum, but it appears most of them out there are inactive. This place seems fairly active :stoned

  • Author
    Posts