Ryan
Forum Replies Created
- Posts
x2 that or get a 4000rp with 1.3 and youll be golden[/quote]
Yeah after using the 3000rp for so long and no complaints I was optimistic about the 4000 but got one a month ago and you. Couldn’t have said it better its Golden !
All Materials are Sikkens system . the blowers are cheaper brand but blow air .
I clean my filters on my blowers with my base gun after every job just routine , I can control the air balance in the booth been keeping an eye on that and makiuing the adjustments to keep it in the blue. I will change my hose and the anti static wipe how long after doing this step should I wait to start spraying my blender and sealing ? I was also wondering if I am waiting long enough after clearing before I turn the bake on ? cause that’s a lot of moving air when that kicks in .
But in all seriousness I never really thought about the hose I wipe it down but its old .
[quote=”hating-painting” post=34045]What type of masking paper are you using?
How old is the hose from the filter to the gun?
Since you are Canadian, it could be the flannel paint suits you guys wear. :lol1[/quote]
HaHa dont forget the Long johns and tuque
My jobs start with me feather edging the bodymens work to prime,then block sand prep and refinish.As soon as I get my job I blow off the entire vehicle OTO the panels being sprayed then sand mask and prime st2 block sand blow off with tack rag then put in booth mask off area with 18″wide paper then plastic off of paper (ran into a problem few years ago with plastic taped to edge of area being painted)then blow off wipe down with M600 then mix blender tack off then spray blender. mix color tack spray turn blowers on then tack after coverage ,tack myself and clear. The booth is coated with booth coat that stays tacky and I also hasve just started using that Devilbiss dust control floor spray.I also wear full suit hood up,gloves,and respirator. Thanks for the concern Jayson M.
I used the 3000RP for years with a 1.3 tip at 35psi stick that 3.5-4 inches away from your panel and you will get all the material and speed you will need . 😛