Renzhi

Forum Replies Created

  • Author
    Posts
  • Renzhi
    May 18, 2011 at 7:16 pm #30912

    Hey Damien, do you have any suggestions for ventilating a garage? I only have 2 box fans to circulate the air in my garage, my garage is opened on one end and has a roller door on the other, if i open my roller door then i the air circulation increases significantly, do you think this will lead to more dust in my paint?

    Renzhi
    May 18, 2011 at 10:05 am #30907

    hey guys, what kind of filters do you use for spraying at home?

    Renzhi
    May 15, 2011 at 3:52 pm #30865

    I only have a filter regulator after 20meters or so of airhose and a desiccant snake before the spray gun

    Renzhi
    May 15, 2011 at 10:24 am #30862

    the problem is evenly distributed throughout the paint, the first time i sprayed it when i mixed the paint wrong it had the same problem aswell among others and after letting the paint sit for 20 hours i sanded the roof again

    Renzhi
    May 15, 2011 at 5:26 am #30859

    5LEater, im using Wattyl Colourthane Clear

    Renzhi
    May 14, 2011 at 8:33 pm #30854

    Ok so i googled around and the finish was similar to the picture below but the bumps are smaller and can only be seen when close to the panel and around a point of light. The guy who took the picture apparently had solvent pop as the problem but i followed the manufactures recommendations when spraying so I didn’t think that would be the same problem i’m having

    http://hotrodders.com/forums/attachment.php?attachmentid=4408&stc=1

    Renzhi
    May 14, 2011 at 8:04 pm #30853

    Hi Ben, I think I removed all of the previous clear coat, the first time i sanded it looked like there were a few spots which broke through the clear into the basecoat and when I sanded the second time there were more spots so i assume i had removed the badly mixed clear coat and more.

    Hi Ding, I don’t think its the solvent reacting with the old basecoat as the little bumps are evenly distributed throughout the pint job and not just on a few spots

    Renzhi
    April 19, 2011 at 11:23 pm #30387

    I can get a longer air hose about 100ft of it but i don’t know where to get copper pipes or how to plumb it. If i can’t get any copper is there an alternative? get a desiccant filter perhaps?

    Renzhi
    March 23, 2011 at 9:07 pm #29736

    can you also use lacquer thinnner to thin urethane paints?

    Renzhi
    March 23, 2011 at 7:24 pm #29733

    noob question but what’s a carb cleaner?

    Renzhi
    March 5, 2011 at 10:22 pm #29158

    The biggest thing i would paint at one time would probably be a door on a medium sized car and it probably won’t be too often maybe 5-6 times in a year

  • Author
    Posts