Tim
Forum Replies Created
- Posts
Hey Bud… :welc
two speed 24 inch barrel fan works on a budget.
been using one for 7 years.
89 bucks at Home Depot. :blush:Sprayed a 5gal bucket down with unactivated urethane single stage and put it out in the sun.
8 months later it still prints.
Take ryan’s advice. You gotta messy job so like ben said be careful.Dark corners and painting blind….been there done that…LOL!!! still there..HA!! :wak
What is that DTM Urethane Bob?
I thought all the DTM were epoxy “hybrids”.
Just wondering cause I have used urethane, epoxy, epoxy-hybrid, and polys…..plus… :pcorn:from the sound of it i would not be concerned with too much primer…
with karma like bondo’s who can argue!! LOL! :rock
good point bondo. :clappy
i start my filler sanding with 80 (or 40…depends), finish with 180 then urethane prime.
wet sand 400/600 :blink:
You might have a ‘brow ring’ poking up that needs to be relieved, (pecked down). then refilled.
got pics? :pcorn:nice…gotta put the foam on thick so ya can shave it i thought :rock
pics plez….video better!
Takes application to make it look that way huh..HA! try the poly trick on that one.
😉:clappy
Good one Stone!:clappy
Amazing what a little cut and buff can do..LOL! :dncI don’t do framework… :pcorn:
flat rate would definitely be the ticket…more power to ya doc!
I’ll have to go with ryan on this one…ding